17 Cables de energía para baja tensión | Low voltage power cables AL VOLTALENE FLAMEX CPRO (S) - AL XZ1 (S) Tensión asignada | Rated voltage: 0,6/1 kV Norma diseño | Design standard: UNE-HD 603-5X-1 Designación genérica | Generic designation: AL XZ1 (S) Maximum permitted voltage As stated in the technical data on this sheet, the Al Voltalene Flamex CPRO (S) cable can withstand the following maximum voltages: The rated voltage for Al Voltalene Flamex CPRO (S) is 0.6/1 kV. Its insulation complies with the specifications in IEC 60502-1. In Point 4.1 of this standard, the following table can be found: The short circuit current limit value for an insulated conductor is calculated according to the following formula found in UNE 21192 (IEC 949): Where: I: short circuit current [A]. K = 94 (aluminium conductor & XLPE insulation) [A·s 1/2/mm2]. S: conductor cross-section [mm2]. t: duration of the short circuit [s] (duration between 0.1 and 5 seconds). You can use the formula to calculate short circuit density values I/S for different duration values. You just need to multiply the table value by the conductor cross-section in each case. Tensiones máximas admisibles Según se recoge en las características técnicas de esta ficha el cable Al Voltalene Flamex CPRO (S) soporta las siguientes tensiones máximas: La tensión asignada del Al Voltalene Flamex CPRO (S) es 0,6/1 kV. Su aislamiento cumple las especificaciones de IEC 60502-1. En el punto 4.1. de dicha norma encontramos la siguiente tabla: El valor límite de corriente de cortocircuito para un conductor aislado se obtiene según la siguiente fórmula deducible de UNE 21192 (IEC 949): Siendo: I: intensidad de cortocircuito [A]. K = 94 (conductor de aluminio y aislamiento de XLPE) [A·s 1/2/mm²]. S: sección del conductor [mm²]. t: duración del cortocircuito [s] (tiempos de duración entre 0,1 y 5 segundos). Con la fórmula, podemos obtener valores de la densidad de cortocircuito I/S para diferentes valores de duración del mismo y para aplicar a cada caso sólo es necesario multiplicar el valor de tabla por la sección de conductor. Tensión máxima permanente permitida para el cable Al Voltalene Flamex CPRO (S) (kV) Maximum permitted permanent voltage for the Al Voltalene Flamex CPRO (S) (kV) cable Corriente alterna Alternating current Corriente contínua Continuous current Conductor / tierra Conductor / earth Conductor / conductor Conductor / conductor Conductor / tierra Conductor / earth Conductor / conductor Conductor / conductor 1,2 1,2 1,8 1,8 Tensión más elevada del sistema (Um) kV Highest voltage in the system (Um) kV Tensión asignada (Uo) kV Rated voltage (Uo) kV Categorías A y B Categories A & B Categoría C Category C 1,2 0,6 0,6 3,6 1,8 3,6* *Esta categoría está cubierta por los cables 3,6/6 (7,2) kV según norma IEC 60502-2. *This category is covered by the 3,6/6 (7.2) kV cables according to the IEC 60502-2 standard. Duración del cortocircuito (s) Duration of short circuit (s) 0,1 0,2 0,3 0,5 1 1,5 2 2,5 3 Densidad de corriente (A/mm²) Current density (A/mm²) 297 210 172 133 94 77 66 59 54
RkJQdWJsaXNoZXIy MjY3Mzk=